Salt spray chamber -1
Tests in corrosion chambers are commonly used to evaluate the behaviour of metallic coatings, paints and treatments and coated metal pretreatments.

Salt spray chamber
This advanced programmable test chamber has been developed to subject the samples to controlled temperature changes, salt spray environments, constant temperature drying, forced air drying, High humidity at constant temperature and with temperature cycles.

Kesternich testing cabinet
This unit is a special cabinet designed to perform Kesternich tests in order to evaluate the SO2 corrosion resistance.
This cabinet has a volume of 300 litres, and a controlled resistance able to maintain an internal temperature up to 40 ºC inside the cabinet.

Salt Spray Test Cabinet
This programmable cabinet for corrosion testing is designed to develop salt spray, humidity and drying tests.

Frequency Response Detector
The frequency response detector is designed to perform electrochemical impedance measurements that provide information about the corrosion process.
The model 1025 is able to perform frequency scans in a range between 10 Hz and 5 MHz, with a voltage amplitude between 1 mV and 1 V.

Potentiostat-Galvanostat
Model 273A can performa almost any electrochemical measurement. It can be controlled either from the front panel or from a computer. The software helps to apply various electrochemical corrosion measurement techniques, such as potentiodynamic polarization, Tafel plots, polarization resistance, cyclic polarization, potentiokinetic reactivation, potentiostatic, galvanostatic, and galvanic corrosion studies.

Stress Corrosion cracking machine
Testing machines EM1, reach a huge load range, for static and near static tests for all kind of materials: metals, plastics, textiles, rubbers... Load can be applied from 5 KN to 500 KN or even 1000 KN and in traction and compression test.

Cyclic corrosion test chamber
Corrosion cabinet testing is used to evaluate metallic coatings, paint coatings, as well as chemical treatments and paint pretreatments.

Coil Coating Pilot Line
This equipment allows the simulation of organic and inorganic coatings on metallic flat substrates.
The main equipments of this line are the roll-coater and the convection furnace. They are used when working in discontinuous way with small samples.

Cold rolling mill
The main characteristics are: Max. entrance thickness: 5 mm, Min. exit thickness: 0.14 mm and Max. load: 200 Tn.

Phosphatizing pilot plant
The pilot plant consists of seven baths that reproduce industrial conditions across the stages of degreasing, surface activation, phosphating, intermediate washes, passivation and final washes with deionized water.

Goniometer model "OCA 20"
DATAPHYSICS' contact angle meter model "OCA 20" allows to measure not only the angle of contact between a deposited drop of water and the substrate based on the contour of that drop, but also the surface tension in accordance with standard evaluation methods.